Ford XR6 Turbo Barra Rebuild Kit with Spool Drag Pro I Beam Conrods and CP Bullet Forged Pistons

Beschreibung

Spool Ford XR6 Turbo Rebuild Kit with CP Bullet Forged Pistons and Drag Pro I Beams

These CP Bullet Pistons are rated at up to 1000hp

Available in:

• Bore: +0.5mm, +0.25mm, and *STD
• Comp Ratio: 9.0:1

This Rebuild Kit includes the following quality parts:

• Spool Forged Drag Po I Beam Conrods with 7/16 ARP 2000 Fasteners
• CP Bullet Forged Pistons with 4 x Valve Reliefs (Rings, Pins and Locks Included)
• Cometic MLS Head Gasket
• ACL Race Series Main Bearings – STD or 0.25mm
• ACL Race Series Big End Bearings – STD or 0.25mm

These Spool CP Bullet Pistons feature:

• 4 x Valve Pockets
• 2618 Forged Alloy
• Offset Gudgeon Pin
• 0.200” 51 pins STD
• Upgraded 0.200” and 0.250” 9310 pins are available when adding to cart.
• Includes piston rings, pins and pin locks.

Spool Drag Pro I Beam connecting rods are the ultimate high strength direct fit Conrod for all Ford XR6 Turbo engines.

With new features like:

• Upgraded ARP2000 7/16 bolts
• Increased strength to the beam
• Increased strength around the fasteners / bolts
• Increased strength around the gudgeon pin

Spool Connecting Rods Feature:

• ARP 2000 fasteners (L19 fasteners are available as an upgrade)
• High tensile 4340 forged steel
• 2 Piece forging
• Hardness of HRC36-42
• Dowelled caps for precision alignment
• X-RAY & Sonic tested
• Quenching and heat treated
• Shot peened
• 100% Magnafluxed
• Weight Matched Sets +/- 1 gram
• Vacuum degassed to remove impurities

Please Note:

*STD bore size pistons are not recommended in a used bore for any performance engine unless the bores have done minimal work with minimal wear and the correct piston to bore clearance can be adhered to.

All piston manufacturers have a specific piston to bore clearance that they recommend. If STD bore pistons are requested and there is a piston to bore clearance issue we will not exchange or refund, due to the reasons given above.